Publicité
Spindle index
The headstock has 24 indexing holes with a spacing of 15°, which allows accurate working with
patterns, such as straight grooves, slots or bores.
The indexing pin is only for positioning the workpiece!
Never switch on the machine when the indexing pin is set, as damage to the
machine may result!
Only handle the indexing pin when the machine is at a complete standstill!
OPERATION
Only operate the machine when it is in a perfect condition. A visual inspection of the machine
must be carried out before each operation. Safety devices, electrical cables and operating
elements must be checked carefully. Check screw connections for damage and tight fit.
15.1
Operating instructions
When operating the machine, be sure to observe the following instructions:
Take time to familiarise yourself with how the machine works, the tools and the types of
•
wood.
•
Ensure that the machine has a level and stable base.
•
Before switching on, turn the workpiece by hand to ensure that it runs freely and does
not touch the tool rest. Check that the workpiece is centered and firmly clamped.
•
Check the tool rest for firmly seating before starting.
Check the tailstock and centre punch tip for tight fit before starting! The centre punch
•
tip should penetrate the workpiece by up to a few mm, depending on the size of the
workpiece.
Check the face plate and, if used, the spur center for tight fit before starting.
•
Provide the workpiece with a centring hole on both sides before clamping between two
•
centres.
Check that the indexing pin is loosened.
•
Hold and guide the woodturning tool securely and firmly when working.
•
•
Only work with sharp turning tools.
•
Observe the direction of rotation when positioning the turning tool.
Only work on large and unbalanced workpieces at low spindle speed.
•
Adapt the workpiece to its basic shape before turning, if possible.
•
Use the face plate for large and unbalanced workpieces.
•
•
Adjust the spindle speed to the material properties.
Observe the specifications regarding workpiece dimensions.
•
Only work on selected woods without defects.
•
15.2
Handling
Deactivate spindle lock
The indexing pin must be in the deactivated position and the spindle must be rotatable before
you switch on the machine.
HOLZMANN MASCHINEN GmbH
C AU TI O N
• Turn the spindle to the desired position.
• Pull the indexing pin (1), turn it 90° and release it.
The spindle is locked in the desired position.
To unlock the spindle, reverse the procedure.
• Pull the indexing pin (1), turn it 90° and release it.
www.holzmann-maschinen.at
OPERATION
34
D510F_230V
Publicité
