Publicité
Use a supply cable of type H07RN (WDE282) or take the required cross-section of the
•
supply cable from a current carrying capacity table. Pay attention to the measures for
protection against mechanical damage.
Make sure that the power supply is protected by a residual current circuit breaker.
•
•
Connect the machine only to a properly grounded socket.
When using an extension cable, make sure that the dimension matches the connected
•
load of the machine. The connection power can be found in the technical data, the
correlation of cable cross-section and cable lengths can be found in the technical
literature or obtain information from a specialist electrician.
A damaged cable must be replaced immediately.
•
14.3
Assemble
Parts of the machine have been disassembled for transport and must be reassembled before
use. Follow the instructions below:
14.4
Anchor to the work table
To prevent the machine from slipping while working, anchor the machine to the work table.
HOLZMANN MASCHINEN GmbH
Tool rest
• Position the tool rest base along the machine bed and
fix it with the locking lever (1).
• If the tool rest base cannot be moved, loosen the nut (2)
on the underside.
• Position the tool rest into the opening provided, set the
desired height and fix it with the locking handle (3).
• If necessary, rotate the tool rest.
Headstock
• Loosen the two opposite worm screws of the
handwheel.
• Position the handwheel onto the headstock shaft.
• Make sure that the flat part of the shaft touches the
worm screw.
• Fix the worm screws (4).
Tailstock
• Loosen the two opposite worm screws.
• Slide the handwheel onto the shaft of the tailstock.
• Make sure that the flat part of the shaft touches the
worm screw.
• Fix the worm screw (5).
Tool holder
• Fix the tool holder with the two screws and washers to
the holes provided (6).
• Connect the machine to a flat work surface or work
table with 4 screws.
NOTE:
delivery content.
www.holzmann-maschinen.at
Required fixing material is not included in the
ASSEMBLY
31
D510F_230V
Publicité
