Publicité
Mark the centre of the workpiece
The marking of the centre of the material enables exact clamping of the workpiece.
Clamp workpiece
Longitudinal machining
For longitudinal machining, the workpiece is clamped centred.
Front machining
With optionally available clamping devices you can clamp larger workpieces securely and firmly,
see chapter ACCESSORIES.
Position the tool rest
-
Position the tool rest, depending on the turning tool, just above or just below the centre
line of the workpiece at a distance of 1–3 mm.
-
Use the tool rest to safely guide and support the turning tool.
Risk of injury from parts flying off!
Before switching on the machine, check whether
the face plate and/or the spur center,
the tailstock,
the centre punch tip and
the tool rest are fixed.
Make sure that the workpiece is firmly clamped!
Switch the machine on and off
Do not machine the workpiece with the tool until the machine has reached the
set spindle speed.
Do not increase the spindle speed until the workpiece has reached a regular
runout in its basic shape.
HOLZMANN MASCHINEN GmbH
• Mark the center (2) on both faces of the workpiece.
Spur center
• Attach the workpiece by drilling the claws of the spur
center into the workpiece (3).
Centre punch tip
• Loosen the locking handle (4).
• Turn the handwheel (5) until the centre punch tip has
bored a few mm into the workpiece (6).
• Fix the locking handle again (4).
Face plate
• Fix the workpiece with suitable Spax screws, which are
drilled into the workpiece through the holes in the face
plate (7).
NOTE:
The Spax screws are not included in the delivery
content!
Make sure that the Spax screws do not penetrate the area of
the workpiece where material is to be removed.
• Screw the face plate with the attached workpiece onto the
thread of the headstock shaft.
WAR N I N G
N O TE
www.holzmann-maschinen.at
OPERATION
35
D510F_230V
Publicité
