Publicité
ASSEMBLY
Due to the high weight, there is an increased risk of crushing and tipping, which can
result in serious injury or even death. Therefore, at least two persons are required to
set up the gear drilling machine.
When assembling, make sure that all surfaces are clean and that any burrs that may
have formed during a previous disassembly are removed first.
14.1 Preparatory Activities
14.1.1 Check Delivery Content
Check the machine immediately after delivery for transport damage, missing parts and loose
screw connections.
14.1.2 Selecting Installation Site
Choose a level, firm surface with sufficient space for the machine to be installed. The floor at the
place of installation must be able to support the load of the machine. The minimum space
required for the machine is determined by its dimensions plus a safety area of 80 cm around the
machine. The installation site must also meet the ergonomic requirements of a workplace.
14.1.3 Fixing the Machine
Excessive tightening of the fastening screws in conjunction with an uneven surface
can cause the base of the machine to break. Only tighten the fastening screws to
such an extent that a secure anchorage is guaranteed and the machine is prevented
from tilting during operation.
14.1.4 Preparation of Surfaces
Remove the anti-corrosion agent applied to the bare parts of the machine for transport and
storage and oil the relevant machine parts with an acid-free lubricating oil.
14.2 Filling in Gear Oil
The machine is delivered without lubricant. Therefore, fill in gear oil and lubricate all relevant
machine parts before the first start-up - for details see section Maintenance. Use a lubricating oil
of type SAE68 or equivalent to lubricate the gear unit!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WARNING
NOTE
NOTE
After alignment, anchor the machine firmly to the
ground (see illustration on the left). Use washers
for levelling to avoid damaging stresses when
tightening the nuts.
ASSEMBLY
35
ZX 50PC
Publicité
