Publicité
12.5 Suppplementary Safety Instructions for Drilling/Milling Machines
Use collets or a vice to prevent the workpiece from turning when drilling or cutting. This is
•
safer than holding the workpiece by hand and leaving your hands free to operate the
machine.
Make sure that the drill or cutting tool is securely locked in the chuck.
•
•
Make sure that the chuck key has been removed from the chuck before turning on the
power.
Adjust the table or depth stop to avoid drilling into the table.
•
For your own safety, do not wear gloves when drilling/milling.
•
Turn off the power, remove the twist drill or cutting tool and clean the table before leaving
•
the machine.
12.6 Hazard Warnings
Despite their intended use, certain residual risks remain. Due to the design and construction of
the machine, hazardous situations may occur when handling the machines, which are identified
as follows in these operating instructions:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for error-free operation of
the machine. Safe working depends primarily on you!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
DANGER
WARNING
CAUTION
NOTE
SAFETY
33
ZX 50PC
Publicité
