Publicité
SAFETY
This section contains information and important notes for safe commissioning and handling of the
ZX 50PC drilling and milling machine.
For your own safety, read these operating instructions carefully before putting the
machine into operation. This will enable you to handle the machine safely and
prevent misunderstandings as well as personal injury and damage to property. In
addition, observe the symbols and pictograms used on the machine as well as the
safety and hazard information!
12.1 Intended Use
The machine is intended exclusively for the following activities: The production of drill
holes/threads as well as milling in cold metal or other non-hazardous or non-combustible
materials within the specified machine limits.
HOLZMANN MASCHINEN
beyond this and for any resulting damage to property or injuries.
12.1.1 Technical restrictions
The machine is intended for use under the following ambient conditions:
Rel. Humidity:
Temperature (operation)
Temperatur (storage, transport)
12.1.2 Prohibited applications / Hazardous misapplications
-
Operation of the machine without adequate physical and mental aptitude
-
Operating the machine without knowledge of the operating instructions
-
Changes in the design of the machine
-
Operating the machine in a potentially explosive environment
-
Operating the machine outside the limits specified in this manual
-
Remove the safety markings attached to the machine.
-
Modify, circumvent or disable the safety devices of the machine.
-
Operating the machine without coolant
-
Operating the machine without sufficient oiling
The improper use or disregard of the versions and instructions described in this manual will result
in the voiding of all warranty and compensation claims against Holzmann Maschinen GmbH.
12.2 User requirements
The physical and mental suitability as well as knowledge and understanding of the operating
instructions are prerequisites for operating the machine.
Please note that local laws and regulations may stipulate the minimum age of the
operator and restrict the use of this machine!
Before working on the machine, remove rings, bracelets and wristwatches, tie long hair together if
necessary, always wear tight clothing when working on the machine and always fold long sleeves
inwards only.
Work on electrical components or equipment may only be carried out by a qualified
electrician or under the supervision and supervision of a qualified electrician.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
assumes no responsibility or warranty for any other use or use
max. 65 %
+5° C bis +40° C
-25° C bis +55° C
SAFETY
31
ZX 50PC
Publicité
