Publicité
Adjust the riving knife and the saw blade guard after each saw blade change.
Assembly / exchange / adjustments scoring saw blade
HOLZMANN Maschinen GmbH
- Fix the drive shaft with the supplied fixing pin (5).
- Loosen the flange nut (4) with the saw blade wrench (6) (left-
hand thread!).
- Remove flange nut (4), flange (3) and saw blade (2) from the
drive shaft.
- Clean the drive shaft, shaft flange (1) and all parts thoroughly
from impurities.
- Replace the old saw blade with a new one.
- Make sure that the new saw blade is undamaged and not
dirty.
- Place the saw blade (2), flange (3) and flange nut (4) on the
drive shaft.
- Fix the drive shaft with the supplied fixing pin (5).
- Tighten the flange nut with the saw blade wrench (6)
(left-hand thread!).
NOTE:
Retighten the flangenut tightly to prevent the nut from
loosening during operation
(tightening torque: 50 Nm).
- Close the saw blade guard.
- Bring the sliding table back into position.
- Adjust the cutting height to the maximum possible
- Set the saw blade to 90°.
- Push the sliding table all the way foreward.
- Open the saw blade guard (7).
- Fix the drive shaft with the supplied Allen key (6).
- Loosen the flange nut (4) with the saw blade
- Remove flange nut (4), flange (3) and scoring saw
- Clean the drive shaft, the shaft flange (1) and all
- Replace the old scoring saw blade with a new one.
- Make sure that the new scoring saw blade is
- Place the scoring saw blade (2), flange (3) and
- Fix the drive shaft with the supplied Allen key (6).
- Tighten the flange nut with the saw blade wrench
- Close the saw blade guard.
- Bring the sliding table back into position.
NOTE:
adjusted so that it cuts a slot of a depth of 1.5 – 2 mm.
The scoring saw blade has to be oriented exactly to the
main saw blade.
Adjustments:
- Adjust main saw blade to 90°.
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O TE
level.
wrench (5) (right-hand thread!).
blade (2) from the drive shaft.
parts thoroughly from impurities.
undamaged and not dirty.
flange nut (4) on the drive shaft.
(5) (right-hand thread!).
NOTE:
Retighten the flangenut tightly to prevent the
nut from loosening during operation
(tightening torque: 25 Nm).
The height of the scoring blade must be
57
FKS400V32TOP_400V
Publicité
