Publicité
Basic knowledge of woodworking especially the knowledge of the relationship between wood, tools,
saw blade, cutting speeds and rotational speeds.
Please note that locally applicable laws and regulations determine the minimum age of the operator
and may restrict the use of this machine!
Work on electrical components or equipment may only be carried out by a qualified electrician or
under the guidance and supervision of a qualified electrician.
Put on your personal protective equipment before working on the machine.
12.3
Safety devices
The machine is equipped with the following safety devices:
12.4
General safety instructions
To avoid malfunctions, damage and health impairments when working with the machine, the
following points must be observed in addition to the general rules for safe working:
Check the machine for completeness and function before starting. Only use the machine if
•
the separating and other non-separating protective devices required for machining have
are fitted.
•
Make sure that the guards are in good working order and properly maintained.
Select a level, vibration-free surface as the installation area.
•
Ensure sufficient space around the machine.
•
•
Ensure that the machine is on a firm footing.
Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
•
Ensure a clean working environment.
•
Keep the area around the machine free of obstacles (e.g. dust, chips, cut-off workpiece
•
parts, etc.).
Only use tools that are in perfect condition and free of cracks and other defects (e.g.
•
deformations).
Remove tool keys and other setting tools before switching on the machine.
•
•
Check the machine's connections for strength before each use.
Never leave the running machine unattended. Switch off the machine before leaving the
•
working area and secure it against unintentional or unauthorized restarting.
The machine may only be operated, maintained or repaired by persons who are familiar
•
and who have been informed about the dangers arising from this work.
HOLZMANN Maschinen GmbH
A self-locking Emergency Stop on the control panel and
on the machine backside to stop dangerous movements
at any time.
Safety guard (adjustable): Saw blade guard (1), to cover
the saw unit.
Riving knife (2), to reduce the risk of wedging the
workpiece. The setting is in horizontal and vertical
direction opposite to the saw blade.
Push stick (3): For cutting operations where less than
120mm is cut, i.e. less than 120mm distance to the right of
the saw blade to the rip fence. Do not feed the wood by
hand, but with the push stick.
Interlocking movable guard:
Safety cover of the saw blade (equipped with a safety
switch) This safety switch interrupts the power supply
immediately when the cover is opened.
Interlocking movable guard:
Maintenance door (equipped with a safety switch) This
safety switch interrupts the power supply immediately
when the cover is opened.
www.holzmann-maschinen.at
SAFETY
41
FKS400V32TOP_400V
Publicité
