Publicité
Mitre cuts
Depending on the workpiece size, set the desired angle on the mitre fence or on the cross-cut
fence.
Angled cuts with inclined saw blade
Symbolpicture
Longitudinal cut of boards
Use the down holder for cutting and fixing boards and avoiding a kickback.
15.3
Operating
Switch the machine on and off
Switch on the machine:
1. Turn main switch (6) to position I (ON).
NOTE:
Power indicator light (1) lights on.
2. The main saw blade starts after pushing the button (2) I (ON).
HOLZMANN Maschinen GmbH
Mitre gauge
- Loosen the locking screw (1) and set the desired angle.
Fix the locking screw again.
- Loosen the knurled screw (2) and position the mitre
gauge. Tighten the knurled screw again.
- If necessary, loosen the clamping screws (3) and move
the fence. Tighten the clamping screws again.
Cross cut fence
- Depending on the workpiece size and angle, select a
rotation point in the outrigger table and fix the cross-
cut fence.
- Loosen clamping 90° (4) and clamping screw (5).
- Adjust the angle of the cross cut fence
- Read off the set angle on the scale (6).
- Fix clamping screw (5).
- Fix the workpiece.
- Use the sliding table to move the workpiece evenly.
- Adjust the desired inclination of the saw blade (13).
- Adjust the saw blade guard (14).
- Adjust the rip fence (15) or the cross-cut fence (16).
- Fix the workpiece with the downholder (17).
- Make the cut.
- Mount the down holder (1) in the groove of the sliding
table.
- Set the desired dimension with the rip fence or the
cross-cut fence.
- Make the cut.
www.holzmann-maschinen.at
OPERATION
54
FKS400V32TOP_400V
Publicité
