Publicité
HOLZMANN Maschinen GmbH
-
-
-
-
-
-
-
Saw blade guard:
-
-
-
-
-
-
-
Table settings:
-
-
-
NOTE:
Position A: for straight cuts
Position B: for angle cuts
www.holzmann-maschinen.at
1.
Bracket saw blade guard
Mount the bracket saw blade guard (1) on the
machine as shown.
To do this, first remove the screws and spacers (2)
from the retaining bolts.
Place the bracket saw blade guard on the
retaining bolts and fix it with screws and spacers
(2).
Mount the bracket saw blade guard short (4) on
the bracket.
To do this, first remove the bolt and nut (3) from
the holder.
Position the bracket as shown.
Insert the bolt again and fix it with the nut (3).
Set the lock (7) to the "Open" position.
Slide required saw blade guard (6) onto saw blade
guard holder (5).
Set lock (7) to "Lock" position
2.
Table extension / table widening
Remove the screws, spring washers and washers
(1) from the threads (2) in the worktable.
Position the table extension (3) and table
widening (3a) on the worktable as shown.
Fix screws, spring washers and washers.
Check alignment and adjust table if necessary.
Loosen the screws (1) slightly.
Adjust and fix plane and horizontal alignment
with set screws (4).
Tighten the screws firmly.
3. Rip fence
- Mount the ruler (1) and rip fence guide (2) as
shown.
- Adjust parallelism with screws and nuts (3).
- Disassemble the end stop (4).
- Set clamping lever (5) to position not fixed and
slide the fence bracket (6) on the fence guide.
- Remount the end stop.
- Slide the rip fence (7) on the guidance of the
bracket.
2 possible positions.
- Fix the rip fence with the clamping lever (8) on
desired position.
- Mount the dirt wiper (9) as shown.
ASSEMBLY
46
FKS400V32TOP_400V
Publicité
