Publicité
HOLZMANN Maschinen GmbH
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
www.holzmann-maschinen.at
4.
Sliding table
Place the sliding table (1) on the machine and fix it
at the fixing points (2) using screws, spring
washers and washers (3). Do not tighten the
screws before adjusting of the sliding table is
finished.
Level the edge of the sliding table with that of the
work table (using a spirit level) until it is
horizontally aligned without gaps.
NOTE:
Over the entire length, the distance between
the two table edges must be within 12 mm.
Furthermore, it should be aligned exactly to the rip
fence / saw blade.
Then tighten the screws.
5.
Sliding table support/end handle/handle
Fix the support (1) on the end of the sliding table
with 4 screws, spring washers and washers as
shown.
Adjust the height (4) with the set screw.
Fix end handle with 4 screws.
Hook handle (3) in desired position and fix it with
clamping lever.
6.
Outrigger table
Place the bracket of the outrigger table (1) on the
sliding table as shown.
Place the holder of the outrigger table on the
swivel arm support (2).
Tighten the clamping levers (3) of the outrigger
table to fix the position.
Adjust the horizontal alignment with the
adjusting screws (4).
Insert the pivot mount of the crosscut fence (5)
into the front or rear hole of the outrigger table
and fix it with clamping 90° (6).
Insert the groove stone of the support fixing into
the opening, push the groove stone into the
groove of the support (7) and fix it in the desired
position with the fixing screw (8).
Push the flip stops (9) into the groove of the cross
cut fence.
Fix the magnifiers (10) with screws.
Secure the crosscut fence in desired angle
position with clamping screw (11).
ASSEMBLY
47
FKS400V32TOP_400V
Publicité
