Publicité
OPERATION
Only operate the machine when it is in a perfect condition. Before each operation, a visual
inspection of the machine must be carried out. Safety devices, electrical cables and operating
elements must be checked carefully. Check screw connections for damage and tight fit.
15.1
Operating instructions
Make sure that the saw blade used matches the set speed of the machine and that the
•
diameter of the saw blade is compatible with the machine.
Cracked and deformed saw blades cannot be repaired. They must be replaced
•
immediately with new saw blades.
Make sure that the machine works without vibrations.
•
•
Always use the riving knife and the saw blade guard. Make sure that the riving knife, the
saw blade guard and the height of the saw blade are positioned correctly. The riving knife
must always be aligned with the workpiece. Otherwise there is a risk that the workpiece
will stick and cause kickback.
•
Make sure that the workpiece is in a stable position on the table and is supported by either
the rip fence or the outrigger table during cutting.
Make sure that the work table and the sliding table are parallel to the saw blade.
•
Never stand in the direct cutting line of the saw blade, do not hold any parts of your body
•
in the cutting line. Keep the side of the saw blade whenever cutting.
Never reach over or behind the saw blade with your hand while cutting.
•
Avoid awkward operations and hand positions where a sudden slip could cause your hand
•
to get caught in the rotating saw blade.
When using the cross-cut fence, the workpiece should not touch the rip fence at the same
•
time as cutting.
Use the push stick if the distance between the saw blade and the ruler of the rip fence is
•
less than 120 mm.
Use the downholder to secure the workpiece.
•
•
Guide the workpiece smoothly until the end of cutting.
Avoid jerky movements and changing direction.
•
15.2
Types of cut
Workpiece size
Larger workpieces are moved by pushing the sliding table with little effort. Smaller workpieces can
be pushed over the stationary table top, as with a table saw.
Symbolpicture
Symbolpicture
HOLZMANN Maschinen GmbH
Large workpieces
- Adjust the rip fence or the cross-cut fence. If necessary,
pull out the cross-cut fence.
- Use the downholder to fix the workpiece.
- Use the sliding table to move the workpiece.
- For removal widths less than 120 mm, use the push
stick.
- Angle: Adjust the angle with the cross-cut fence.
Smaller workpieces
- For smaller workpieces, use the mitre gauge. Set the
mitre gauge to 90° to the saw blade and place the
workpiece against it. The rip fence can be used to
support this.
- Use the pushing stick.
- Push the workpiece evenly with the pushing stick.
- Angle: Set the angle with the mitre gauge. You can fix
the angle stop in the groove of the worktable or the
sliding table.
www.holzmann-maschinen.at
OPERATION
53
FKS400V32TOP_400V
Publicité
