Publicité
HOLZMANN Maschinen GmbH
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
www.holzmann-maschinen.at
7.
Saw blade
Adjust the cutting height to the maximum
possible level.
Push the sliding table all the way foreward.
Open the saw blade guard.
Fix the drive shaft with the supplied fixing pin (5)
and loosen the flange nut (4) with the saw blade
wrench (6) (left-hand thread!).
Remove flange nut (4) and flange (3).
Place the well cleaned shaft flange (1),saw blade
(2), flange (3) and flange nut (4) on the drive shaft.
Fix the drive shaft with the supplied fixing pin (5).
Tighten the flange nut with the saw blade wrench
(6) (left-hand thread!).
NOTE:
min. tightening torque: 50 Nm
Close the saw blade guard.
8.
Scoring saw blade
Adjust the cutting height to the maximum
possible level.
Push the sliding table all the way foreward.
Open the saw blade guard.
Fix the drive shaft with the supplied Allen screw
(6) and loosen the flange nut (4) with the wrench
(6) (right-hand thread!).
Remove flange nut (4) and flange (3).
Place the well cleaned shaft flange (1), saw blade
(2), flange (3) and flange nut (4) on the drive shaft.
Fix the drive shaft with the supplied Allen screw
(6).
Tighten the flange nut with the saw blade wrench
(5) (right-hand thread!).
NOTE:
min. tightening torque: 25 Nm
Close the saw blade guard.
9.
Downholder
- Insert the bracket of the downholder (1) into the
groove of the sliding table and fix it in the desired
position.
10. Mitre gauge
- Insert the mitre gauge (2) into the groove of the
sliding table and fix it in the desired position with
the knurled screw (3).
ASSEMBLY
48
FKS400V32TOP_400V
Publicité
