Publicité
3. The scoring saw blade starts after pushing the button (4) I (ON).
NOTE:
The scoring swaw blade can only be started when the main saw blade is activated.
Switch off the machine:
Normal switch-off:
1. After finishing cutting, switch off the saw by pushing the 0 (OFF) button (3)..
2. After finishing work, turn the main switch (6) to position 0 (OFF).
Switching off in emergency situations:
Press the emergency stop (5).
CAUTION: The emergency stop button (5) can only be unlocked after the emergency situation has
been eliminated.
Cutting
• Operating instructions read and followed
• Type of cut and appropriate machine setting selected.
• Switch on the machine
• Wait until saw blade has reached full speed (approx. 10 sec.)
• Carry out cut(s)
• Switch off the machine
• Wait until the machine has come to a complete standstill before moving any bodypart into the
danger area (saw blade) or moving away from the machine.
End operation
When the work is finished, the machine must be switched off.
Lower the complete saw blade and the scoring saw blade
Switch-off the main switch to disconnect the machine from the power supply.
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before cleaning,
maintenance or repair work and secure it against unintentional reconnection.
Wear protective cutting gloves when handling the saw blade and scoring
blade to reduce the risk of injury!!
16.1
Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
After each work shift, clean the machine and all its parts thoroughly.
•
•
Vacuum the wood chips and sawdust. Wipe off any remaining dust with a dry cloth.
•
Use a resin-dissolving cleaner for resin build-up.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
•
(e.g. WD40 rust inhibitor).
HOLZMANN Maschinen GmbH
WAR N I N G
C AU TI O N
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O TE
N O TE
55
FKS400V32TOP_400V
Publicité
