Publicité
Adjustment outrigger table
Cross cut fence
Saw blade speed
Lock of sliding table
HOLZMANN Maschinen GmbH
After losing the clamping lever (1), the outrigger table
(2) can be moved along the slot in the sliding table.
After reaching the desired position, tighten the
clamping lever again.
Position I: see techn. data
Position II: see techn. data
Position III: see techn. data
NOTE:
of the rocker lever, requiring no manual adjustment
The sliding table is secured laterally with a lever (1)
against accidental movement.
To loosen the locking, pull the lever out of the fixation.
www.holzmann-maschinen.at
- Position the outrigger table by loosening the
clamping lever (1) and pushing the outrigger table
into position.
- Adjust the crosscut fence by loosening the
clamping screws and moving the flip stops (3)
- Read off the set measurement from the scale (4).
- Extend the cross-cut fence by loosening the
locking knob (2) and pulling out the rail (2).
- Tighten the locking knob again.
NOTE:
If the workpiece extends more than 1950 mm,
the cross-cut fence must be extended.
Adjusting the distance to the saw blade:
- Remove crosscut fence
- Loosen groove stone (5) and pivot mount (7) with
Allen key (6) and wrench (8).
- Reassemble crosscut fence and fix in desired
position with clamping lever (9).
NOTE:
The groove stone can be fixed to define a
specific position
- Adapt scales to the distance after loosening the
fixing screws (10)
-
Open the maintenance door
-
Rotate the rocker lever (1) downward with a
wrench to the lock position
-
Position drive belt (2) on corresponding motor
belt pulley (3) and drive belt pulley (4)
-
Rotate the rocker lever upward
-
Close the maintenance door
Belt tension will be self-adjusted after flipping
ASSEMBLY
52
FKS400V32TOP_400V
Publicité
