Installation; Internal Knob - Häfele dialock EPC Notice D'emploi Et De Montage

Installation

The installation of the EPC electronic profile cylinder must be car-
ried out by trained qualified personnel. Failing to adhere to these
installation and operating instructions may lead to damages to the
EPC electronic profile cylinder.
Do not close the door before the following installation and commis-
sioning procedures are completed! Otherwise opening the door
from outside will no longer be possible.
The EPC electronic profile cylinder is supplied already lubricated.
Additional lubrication is not required.
Follow the installation instructions for the inside and outside
escutcheons.
Make sure that the dimensions A and B correspond to the cylinder adapter
and the inside and outside escutcheons that are used.
(see Fig. 3 on page 31).

Internal knob

1. Insert the internal knob into the cylinder adapter until it locks into place.
2. Push the cylinder adapter through the inside escutcheon.
3. Insert the cylinder adapter into the mortise lock until the threaded hole
of the cylinder adapter is in line with the drill hole (8) in the mortise lock
for the forend screw (6).
Verify the correct position of the cylinder adapter (2) before screwing
in the forend screw (6). Do not use force! Failing to adhere to these
instructions may destroy the cylinder adapter as well as the lock.
4. Secure the cylinder adapter with the forend screw (6). Check if rotating
the internal knob (1) turns the follower (locking lug) without friction. If
not, correct the position of the cylinder adapter (2).
5. Screw on inside escutcheon.
32 EPC Electronic Profile Cylinder - Status 05.2008 - 732.29.490
Installation and Operating Instructions