Emergency Power Supply; Simple Reset - Häfele dialock EPC Notice D'emploi Et De Montage

Emergency power supply:

If the LED flashes alternately green and red during the unlocking action, the bat-
teries are low and have to be replaced immediately (see Battery replacement).
The unlocking function cannot be guaranteed if the batteries are not
replaced. In this case, a 9 V battery block has to be connected to the emer-
gency power supply unit.
Fig. 6
Then, in order to open the lock, position the emergency power supply unit on
the external knob in such a way that both contacts (see Fig. 7) on the external
knob make contact with the pins of the emergency power supply unit.
After presenting an authorised user key card, the lock can be opened by
turning the external knob.
Fig. 7

Simple reset

In case the EPC electronic profile cylinder was configured incorrectly, or the
programming key card is lost, the EPC electronic profile cylinder can be
reset. Please contact the Dialock Service Hotline (0180 - 50 50 501).
EPC Electronic Profile Cylinder - Status 05.2008 - 732.29.490
Installation and Operating Instructions
Contacts
Pins
41