Operating Principle; Installation Instructions; Prerequisites - Häfele dialock EPC Notice D'emploi Et De Montage

Operating principle

After installation, commissioning and allocating user authorisations, the
EPC electronic profile cylinder is immediately ready for use. If an authorised
user key is presented to the EPC electronic profile cylinder, the external
knob is linked to the cylinder adapter for a certain period of time. This way
the door lock can be operated by turning the external knob.
In order to use the EPC electronic profile cylinder in panic locks, the stand-
ards DIN EN 179 and DIN EN 1125 must be complied with. (See Appendix)

Installation instructions

Prerequisites

A mortise lock in compliance with DIN 18 251 is required for install-
ing the EPC electronic profile cylinder. The lever handle sets must
be designed to suit the mortise lock.
In order to install the EPC electronic profile cylinder, the cylinder
adapter with the appropriate internal and external length (distance
A and B) must be used. When determining the cylinder length, the
height of the (inside and outside) escutcheons must be considered.
The cylinder adapter should be fitted flush with the door fitting
where possible, so that it does not provide a mechanical target for
unauthorised access. A projection of 2 mm should not be exceeded.
If two external knobs are used, the cylinder adapter must not be
shorter than 65 mm.
30 EPC Electronic Profile Cylinder - Status 05.2008 - 732.29.490
Installation and Operating Instructions