Final Assembly - Häfele dialock EPC Notice D'emploi Et De Montage

Final assembly

Make sure that the initial start-up has been completed successfully
before carrying out the final assembly.
1. Push the external knob through the inside escutcheon.
2. Insert the external knob into the cylinder adapter from the outside until it
locks into place.
3. Secure the outside escutcheon with screws.
4. Align the cover (Fig. 4) and push it onto the external knob as far as the
arresting pins.
5. Turn cover until its holes are in line with the pins on the external knob.
6. Present the battery key card to the external knob.
The green and red LEDs flash and an acoustic signal is audible.
7. Present the green programming key card to the external knob.
The arresting pins on the external knob are released.
8. Push in both pins simultaneously using the battery replacement tool, and
completely push the cover over the pins until the pins lock into place.
Fig. 4
9. The pins are re-locked by presenting an authorised user key. In order to
do so, locking authorisation must be allocated first to a user key
(page 36).
The EPC electronic profile cylinder installation has now been completed and
is ready for use.
Locking authorisations can now be allocated to other user keys
using the green programming key card.
EPC Electronic Profile Cylinder - Status 05.2008 - 732.29.490
Installation and Operating Instructions
35