Battery Replacement - Häfele dialock EPC Notice D'emploi Et De Montage

Battery replacement

If during the unocking action the LED flashes alternately green and red and
a short acoustic signal is audible three times, the batteries are low and have
to be replaced immediately.
1. Present the battery key card to the external knob (max. distance 1 cm).
The green and red LEDs flash alternately and an acoustic signal is
audible.
2. Present the green programming key card to the external knob.
The pins on the external knob are released.
3. Push in both pins simultaneously using the included battery replace-
ment tool and remove the cover.
Fig. 5
4. Replace batteries (make sure the polarity is correct, otherwise no signal
is audible).
5. Push cover (Fig. 1, pos. 5) onto external knob (3) up to the pins.
6. Turn cover until its holes are in line with the arresting pins on the exter-
nal knob.
7. Push on cover and allow both pins to lock into place completely.
8. Present user key card to the external knob (an acoustic signal is audible
and the green LED flashes briefly).
The arresting pins are locked.
EPC Electronic Profile Cylinder - Status 05.2008 - 732.29.490
Installation and Operating Instructions
39