Disassembly/Installation; Emergency Opening - Häfele dialock EPC Notice D'emploi Et De Montage

Disassembly/installation

1. Present the disassembly key card to the external knob
(max. distance 1 cm).
The green and red LEDs flash alternately and an acoustic signal is
audible.
2. Present the green programming key card to the external knob.
The installation mode is activated.
3. Turn external knob by at least 180 degrees and pull slightly.
The external knob locks again after 3 seconds. If the disassembly pro-
cedure has not been carried out, repeat the procedure.
For re-installation:
1. Insert external knob.
2. Turn external knob until it locks into place.

Emergency opening

If the green programming key card is lost, please contact the Dialock Hotline
and request an authorising key.
Phone: +49 (0) 180 / 505 05 01.
A reset can be carried out using the Dialock MDU (mobile data unit for pro-
gramming and configuring Dialock components). Please contact your
Dialock service partner.
40 EPC Electronic Profile Cylinder - Status 05.2008 - 732.29.490
Installation and Operating Instructions