Standards - Häfele dialock EPC Notice D'emploi Et De Montage

Standards

DIN EN 179
Selection is made in accordance with the EC certificate of conformity 0432-
BPR-0041 based on DIN EN 179.
Locks marked "b)" may be used.
b) "Locking cylinders do not influence the flawless escape function."
General information: Panic locks that do not require a defined locking lug
position can be used in combination with the EPC electronic profile cylinder.
This has to be considered during the panning stage of the doors.
DIN EN 179 approved locks
Manufacturer
Nemef 1769/56 1769/46 1769/36 1769/35 1769/23 1769/24 1769/32
BKS 2120
DIN EN 1125
When using the EPC in combination with DIN EN 1125 panic exit devices,
the following has to be verified:
• Panic locks that do not require a defined locking lug position can be
used in combination with the EPC. This has to be considered during the
panning stage of the doors.
• The EPC knob must not interfere with the panic function of the pushbar
side. The use of the EPC as a blind cylinder on one side may be
required.
• A pushbar can be used if the above mentioned requirements are met.
2126 2111
EPC Electronic Profile Cylinder - Status 05.2008 - 732.29.490
Installation and Operating Instructions
Model
2119
2119
Secury
2129
45