External Knob; Start-Up; Initial Start-Up - Häfele dialock EPC Notice D'emploi Et De Montage

External knob

Do not yet install the external knob!
Before installing the external knob, the initial start-up procedure
described in the following must be completed. Otherwise the EPC
electronic profile cylinder cannot be removed again in case of mal-
function. The external knob must be installed after the program-
ming key card, clearing key card and at least one user key card
have been allocated correctly during the initial start-up.

Start-up

Do not close the door before the following start-up procedures have
been completed and at least one user key card has been allocated.
Otherwise opening the door from outside will no longer be possible.
Prevent unauthorised use of the programming key cards, clearing
key cards and user key cards.
Always store the programming key cards, clearing key cards and
user key cards in a safe location.

Initial start-up

This step can only be carried out after the batteries have been
inserted for the first time, or after a reset.
This step can only be carried out after the batteries have been inserted for
the first time, or after a reset.
During the initial start-up or after a reset, the green programming key card
and the red clearing key card must be allocated as follows. The following
procedures must be carried out quickly and without interruption.
Please read the complete instructions for the initial start-up procedures first!
Have the green programming key card and the red clearing key card
ready.
EPC Electronic Profile Cylinder - Status 05.2008 - 732.29.490
Installation and Operating Instructions
33