Häfele dialock EPC Notice D'emploi Et De Montage page 43

The simple reset also resets the project code of the EPC. For
the subsequent start-up every special transponder without
authorisation will be accepted.
In case the Dialock MDU is required for the reset, follow the
operating instructions there of.
Procedures
Present the Dialock MDU "beam card" to the EPC electronic profile cylinder
for more than 5 seconds.
The EPC electronic profile cylinder switches into the "simple reset"
mode.
The red LED light is permanently on and the green LED flashes.
Transfer the "simple reset" instruction that can be found in Dialock MDU
"Technician" menu to the EPC electronic profile cylinder.
Subsequently the Dialock MDU reads out the following four figures
and displays them.
• Serial number
• Sum of serial number digits
• Cycle number
• Sum of cycle number digits
These four figures must be provided when calling the Dialock Service Hotline.
In return you will receive two codes.
After pressing the OK key on the Dialock MDU, enter the first code. Press
OK again, then enter the second code
Press OK once again (EPC must still flash) in order to transfer these values
to the EPC electronic profile cylinder.
Two acoustic signals from EPC electronic profile cylinder are audible,
then the green LED flashes for several seconds while the red LED is
permanently on.
The simple reset has been completed.
42 EPC Electronic Profile Cylinder - Status 05.2008 - 732.29.490
Installation and Operating Instructions