ChefLine CHFPG4 Manuel D'instructions page 93

6.2.5 Converting to another type of gas
!
The conversion to another gas must be carried out by an authorised technician.
The oven comes from the manufacturer designed for use with methane gas, unless otherwise specified by the
customer. The oven is supplied with an injector kit (nozzles) for adapting to a different type of gas (Liquid Gas).
Before proceeding with the conversion, close the gas supply and disconnect the oven from the
!
electrical mains.
In order to carry out this operation, the oven's lower front panel must be removed, as indicated below:
1) Remove the screws that secure the front
panel (the parts circled in the figure);
2) Remove the front panel to access the
nozzle.
3) Once the panel has been removed find the unit comprising the air bush and injector (see figure).
The procedure that converts to another gas must be carried out by replacing the injector (nozzle) and adjusting
the primary air as shown in the following table.
Before replacing the injector, check that it has been stamped with the correct diameter

(expressed in 1/100 of a mm) and that it corresponds to the information indicated in the technical
data table (see Tab. 2).
93