SUHNER MACHINING EFC-02 Serie Dossier Technique page 30

S LED c
TaTuS oLoR
Blue Referencing / Calibration
Green Operating within parameters
White Operating at max./min. Position
Red Error
Yellow blinking Service warning
Red blinking Service alarm
The relevant yellow and green display can be use-
ful during manual teach-in of the path.
3.5 f
irmwAre
The following table
versions (see 3.2.4) are required for the functions de-
scribed in the corresponding document (revision see last
page). Higher firmware versions always support preced-
ing functions.
D c
ocumENT oNTRoLLER
REvISIoN waRE
AA-01 2.8.10
AB 2.11.0
4. S
ERvIcE
4.1 p
reVentiVe mAintenAnce
If a service warning / alarm occurs, a SUHNER service
center must be contacted immediately. If the partly com-
pleted machinery continues to be operated after the ser-
vice alarm, trouble-free operation based on the descripti-
on is no longer guaranteed.
Service-Alarm after 2000h „operating hours under load
since last service" or 10'000h „operating hours since last
service",
Service warning 200h before service alarm (see 3.2.2).
4.2 t
rOuBleshOOting
In the event of malfunctions, contact an authorised SUH-
NER aftersales service centre.
4.3 r
epAir
If despite strict observance of the manufacturing and test-
ing method the partly completed machinery should hap-
pen to fail, it must be repaired by an authorized SUHNER
agency.
In all orders to the manufacturer please indicate the com-
ponent serial number of the partly completed machinery.
4.4 w
ArrAnty
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
30
D
EScRIPTIoN
specifies which firmware
F - S F
IRm ERvER IRmwaRE
v v
ERSIoN ERSIoN
4.0.3
4.4.0
/m
aINTENaNcE
non-authorized persons, no warranty shall be in effect for
damages/consequential damages. Complaints can only
be honored if the partly completed machinery is returned
in the undisassembled condition.
If the partly completed machinery continues to be oper-
ated after the service alarm has been issued, any war-
ranty service will be voided.
4.5 s
tOrAge
Temperature range: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C
4.6 d / e
ispOsAl nVirOnmentAl cOmpAtiBility
This partly completed machinery consists of materials
which can be disposed of in a recycling process.
Before disposal, render the partly completed machinery
unusable.
Do not throw the partly completed machinery into
the garbage collection.
According to national regulations this partly com-
pleted machinery must be recycled in an environmentally-
friendly manner.