SUHNER MACHINING EFC-02 Serie Dossier Technique page 25

Mounting on a robot: with interface partial circuit-ø
50mm [ISO 9409-1-50-4-M6]
Screws [ISO4762-M6x12-8.8] (1)*
Centering pin [ISO 2338 ø6 h8 x 20] (2)*
Centering plate [101002441] (3)*
Mounting on a robot: with interface partial circuit-ø
80mm [ISO 9409-1 - 80 - 6 - M8]
Screws [ISO4762 -M8x16 -8.8] (1)*
Centering pin [ISO 2338 - ø8 h8 x 20] (2)*
Centering plate [101002439] (3)*
Mounting on a robot: with interface partial circuit-ø
100mm [ISO 9409-1 - 100 - 6 - M8]
Screws [ISO4762 -M8x16 -8.8](1)*
Centering pin [ISO 2338 - ø8 h8 x 20] (2)*
Centering plate [101002440] (3)*
*Not included within the scope of delivery.
2.2.2 m
Ounting the tOOls
Threaded holes for mounting tools: 6x M8x-16mm (1). At
least 3, symmetrically distributed, are necessary. Center-
ing pin 8mm (2).
2.2.3 m
Ounting the AdApter flAnge
Screw three M8x25 screws into the partly completed ma-
chinery keeping a distance of approx. 8mm.
Move the partly completed machinery with the three
screws into the adapter plate. (1) For correct positioning,
pay attention to the centering pins and the recesses of the
adapter plate! (2)
25