SUHNER MACHINING EFC-02 Serie Dossier Technique page 28

e c :
rrOr Odes
E
RRoR
D
EScRIPTIoN
c
oDE
0 No Error
1 Force >240N
1 Force <-240N
2 Temperature >80°C Hold position
3 Not in Range
4 Sensor Error
The error code: „3" occurs, if holding register values
or values of „Calibration" (see chapter 3.2.3) are outside
the limits. In addition, „Min. position" must be ≤ „Max.
position". When restarting the system, wait 10s after swit-
ching off before switching on. To estimate the payload,
the partly completed machinery must not be in contact
with the workpiece and must be in vertical alignment. If
these conditions are not met: Estimated payload: „-1"
s s :
erVice tAtes
S S
ERvIcE TaTE
0 No Service
1 Service alarm
2 Service warning
O m :
perAtiOn Odes
o m
PERaTIoN oDE
0 None
1 Error
4 Referencing
5 Hold position
6 Calibration
7 Retracted position
8 Extended position
9 Running
3.2.3 c
AliBrAtiOn
Calibration values can be changed on the „Calibration"
page. To do this, change the corresponding value
and confirm with „Submit". „Reset to Factory Calibration"
calls up the values of the factory calibration. It is generally
28
R
ESTaRT
m
ovEmENT bEhavIoR
REquIRED
- no
Extended position yes
Retracted position yes
yes
Hold position no
Hold position yes
D
EScRIPTIoN
D
EScRIPTIoN
recommended not to make any changes to the calibration
values. Deactivated buttons are for factory calibration or
service of the EFC-02. Execution is done by SUHNER.
With an increase of „Bellow Gain" and an adjust-
ment of „Force Offset" and „Weight Compensati-
on", the influence of a cable routed parallel to the
partly completed machinery can be minimized.
l
imits Of the cAliBrAtiOn VAlues
D
EScRIPTIoN
Force Gain -0.000068656...-0.000102984
Force Offset 567.7748902...851.6623353
[N]
Acceleration Gain 0.000121216...0.000181824
Acceleration Offset
-63.3148169...-94.97222534
[m/s2]
Bellow Gain -199.3653981...-299.0480972
[N/m]
Weight Compensation
1.6670182...2.5005273
[kg]
3.2.4 i
nfO
The firmware version can be read here. Deactivated but-
tons are for factory calibration or service of the EFC-02. .
Execution is done by SUHNER.
3.2.4 c
hAnge cOmmunicAtiOn pAthwAy
Communication can be set to web interface or field-bus
(native bus: modbus TCP).
Select communication pathway in the setup in the menu
"Data Origin" New Value and confirm with "Submit".
:
L
ImITS