Software operation
7.4.2
Querying operating hours
7.4.3
Audible signal
7.4.3.1
General
7.4.3.2
Setting an audible signal
30 / 39
5.
Turn to the right with the
'ROTORCHG1' is displayed.
Internal operating hour of the last rotor change
6.
Turn to the right with the
'ROTORCHG2' is displayed.
Internal operating hour of the penultimate rotor change
7.
Turn to the right with the
'OPhoursCHG' is displayed.
Internal operating hour of the last operating hours change
8.
Turn to the right with the
'IMBALCHG' is displayed.
Internal operating hour of the last imbalance cut-off change
9.
Turn to the right with the
'OffsetCHG' is displayed.
Internal operating hour of the last offset adjustment
10.
Press the STOP/OPEN button to exit the menu.
The rotor is stationary.
1.
Press and hold the
'SOUND/BELL' is displayed after 8 seconds.
[SELECT] button repeatedly until 'CONTROL:' is displayed.
2.
Press the
'CONTROL:' and the operating hours are displayed.
[STOP/OPEN] button to exit the menu.
3.
Press the
The audible signal sounds:
■
after a problem occurs in the 2 s interval.
■
after completion of the centrifugation run and rotor standstill in the 30 s
interval.
Opening the lid or pressing any button stops the audible signal.
1.
Press and hold the
'SOUND / BELL ON' or 'SOUND / BELL OFF' is displayed after 8
seconds.
[Rotary knob] to set 'OFF' or 'ON' .
2.
Use
OFF = audible signal disabled
ON = audible signal enabled
[START/IMPULS] button.
3.
Press the
The setting is stored.
'*** ok ***' is displayed briefly.
Rev.: 13 / 01.2024
[Rotary knob] .
[Rotary knob] .
[Rotary knob] .
[Rotary knob] .
[Rotary knob] .
[SELECT] button.
[SELECT] button.
AB2400en