Publicité
Les langues disponibles
Les langues disponibles
Operation
6.2
Removing and installing the rotor
Removing the rotor
1
4
Fig. 16: Rotor installation and
removal
1
Driver pins
2
Rotor hole
3
Driver
4
Motor shaft
Installing the rotor
22 / 39
When the left side of the [STOP/OPEN] button flashes,
press the [STOP/OPEN] button so that the motorised lid
lock assumes the home position (open).
Personnel:
■
Trained user
Close the lid and press the front edge of the lid down gently.
�� The lid locks using a motor.
The left side of the
Personnel:
■
Trained user
1.
Open the lid.
2.
Loosen the rotor clamping nut using the supplied spanner.
�� After passing the working point for lifting the rotor, the rotor
detaches from the cone of the motor shaft (
3.
Turn the clamping nut until the rotor can be lifted off the motor shaft.
4.
Remove the rotor.
2
3
Personnel:
■
Trained user
The lid is open.
1.
Clean the motor shaft (
2.
Lightly grease the motor shaft (
cleaning and disinfection' on page 31 .
3.
Place the rotor vertically on the motor shaft (
The two driver pins (
3 ) when screwing in the rotor.
the driver (
4.
Hand-tighten the rotor clamping nut using the supplied spanner.
5.
Check that the rotor is firmly seated.
Rev.: 13 / 01.2024
[STOP/OPEN] button lights up.
4 ) and rotor hole ( 2 ).
4 ), see ⮫ Chapter 8.2 'Instructions for
4 ).
1 ) on the underside of the rotor must not rest on
4 ).
AB2400en
Publicité
