Publicité
Les langues disponibles
Les langues disponibles
• Place the spark plug connector on the spark plug
(8).
Cleaning the float chamber (fig. Z)
m ATTENTION! Only remove the float chamber
when the engine is cold!
1. Close the fuel valve (11).
2. Loosen the drain plug (t) on the float chamber and
drain the fuel into a suitable container.
3. Attach the drain plug (t) again
4. Loosen the fastening screw (u) of the float cham-
ber.
5. Unscrew the float chamber and radial seal and
thoroughly clean them in a non-flammable solvent
and let them dry. Check the radial seal for dents
and damage.
6. Screw both parts back on.
7. Screw on the fuel valve (11) and check it for leaks.
Please provide the following information in the
event of any enquiries:
• Machine data - type plate
• Engine data - type plate
Important hint in case of sending the plates to a
service station:
Due to security reasons please see to it that the vibra-
tory plates are sent back free of oil and gas!
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Spark plug, oil, belt, rubber pad, air filter
* Not necessarily included in the scope of delivery!
15. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
32 | GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Publicité
