Publicité
Les langues disponibles
Les langues disponibles
38. Drill Pilot Holes for the Strike Jamb
Remove the strike jamb and strike jamb seal from the door.
Open the pivot panel 90 degrees toward the outside of the shower.
Place the strike jamb on the strike jamb spacer and vertically align the strike jamb with the previously installed
painter's tape. Once aligned, secure the strike jamb to the wall using painter's tape.
Using a 9/64" drill bit, drill three pilot holes in the wall using the strike jamb as a template.
Remove the strike jamb and set the strike jamb aside for future installation.
1579984-2-A
Strike Jamb Seal
Strike Jamb
Strike Jamb
46
9/64"
Kohler Co.
Publicité
