Publicité
Les langues disponibles
Les langues disponibles
37. Align the Strike Jamb
5 mm
5 mm
WARNING: Risk of personal injury. Verify that the pivot panel is resting on the install block and that the install
block is securely resting on the threshold before proceeding.
WARNING: Risk of personal injury. Two people are recommended for this step. Place one person inside the
shower and another person outside the shower to adjust the pivot panel for plumb.
Using a 5mm hex wrench, loosen the setscrews on the hinge clamps.
Slide the pivot panel toward the wall until the strike jamb contacts the wall. Verify that the bottom edge of the strike
jamb is seated in the strike jamb spacer.
Using a 5mm hex wrench, tighten the setscrews on the hinge clamps.
Use painter's tape to mark the top, middle, and bottom locations of the strike jamb for future installation.
Remove the install block from the threshold. Save the install block for future adjustments or service.
Kohler Co.
45
1579984-2-A
Publicité
