Kohler Premise K-702479-8L-SHP Instructions D'installation page 20

12. Mark the Wall for Header Alignment
Strike Jamb
Front Back
NOTE: This is NOT an installation step. The strike jamb is being used as a straight edge to mark a location that will be
referenced at a later step.
Place the front side of the strike jamb against the wall.
Insert the alignment tool into the threshold and strike jamb.
Verify that the strike jamb is plumb.
Starting from the top of the strike jamb, use a pencil to draw a line approximately 1" (25 mm) long.
Remove the alignment tool and strike jamb.
1579984-2-A
Strike Jamb
1"
(25 mm)
Alignment Tool
20 Kohler Co.