Publicité
Les langues disponibles
Les langues disponibles
3. Position the Threshold
Grooves
NOTICE: The threshold must sit on a flat surface.
If needed, file the ends of the threshold to fit against the shower walls. Use a coin to match and transfer the corner
radius.
If the shower base/bath ledge is flat: Align the threshold 1/2" (13 mm) from the front of the shower base/bath ledge
along the entire length and mark the location.
If the shower base/bath ledge has a raised edge: Align the threshold 1/4" (6 mm) from the back of the raised edge
along the entire length and mark the location.
Apply 100% silicone sealant into the groove(s) on the bottom of the threshold.
Reposition the threshold at the previously marked location. Verify that the threshold is flush against the fixed panel
wall. Tape the threshold securely in place.
Kohler Co.
1/2" (13 mm)
11
Ledge With Raised Edge
1/4" (6 mm)
1/2" (13 mm)
1579984-2-A
Publicité
