Publicité
Les langues disponibles
Les langues disponibles
21. Install the Pivot Panel Cleat
5/16"
NOTE: The header cover clip may need to be temporarily repositioned to gain clearance to drill the holes in the wall.
Loosen, but do not remove, the screws holding the cleat to the header. Slide the cleat toward the header cover clip.
Using a 5/16" drill bit, drill two holes at the marked locations.
Install the provided wall anchors.
Reposition the cleat against the wall. Install the cleat with the provided #8-18 x 1-1/2" screws.
Verify that the header is flush against the cleat and tighten the two screws securing the cleat to the header.
Kohler Co.
3
2
1
29
#8-18 x 1-1/2"
1579984-2-A
Publicité
