Grillo CLIMBER 9.18 Notice D'emploi page 9

37)Fill the tank with fuel before starting the engine. Only refuel outdoors, always turn off the engine, keep away from sparks or
naked flames, do not smoke! Always replace the cap on the fuel tank and those on fuel containers properly.
38)If the fuel tank has to be emptied, only do so outdoors.
39)Do not operate the grass-cutter over gravel which could become sucked up and drawn into the blade, becoming very
dangerous.
40)At the presence of children, hide the ignition key after using the machine.
41)CAUTION: to avoid the risk of fire, keep the engine compartment, exhaust, discharge outlets, battery, tank area and fuel
pipes free from grass, leaves, dirt etc.
42)Never store the machine with fuel in the tank inside a building where fumes may reach an open flame or spark.
43)Disengage the cutter deck transmission, turn off the engine and disconnect the spark plugs:
a) before cleaning obstructed points.
b) before checking or repairing the brush cutter.
c) when the machine hits a foreign body (check the cutter deck to see if it is damaged).
d) if abnormal vibration occurs, stop and inspect the machine. Contact the nearest authorized
you need help.
TECHNICAL ASSISTANCE
This manual provides instructions for use and basic maintenance of the brush cutter by the user. For operations that are not
described in this manual, contact your Area Dealer.
SPARE PARTS
Only use original spare parts. These are the only parts that ensure safety and interchangeability. Always quote the machine's
serial number and the code number of the part to be replaced when ordering spare parts. For engine parts, follow the
indications given in the specific manual.
WARRANTY
The guarantee is given in compliance with the current law. The dealer will have to give the client a copy of the registration
certificate of the machine, which they will print up from the Grillo website.
For the engine the guarantee of the relative manufacturers apply.
ENGINE: - 9.18 B&S INTEK 7180 OHV 656 cm³ 18 HP gross power – 15,2 HP net power, twin-cylinder, internal combustion.
- 9.22 B&S INTEK 7220 PROFESSIONAL SERIES 22 HP gross power – 18 HP net power 656 cm ³, OHV, twin-cylinder, internal
combustion.
STARTING SYSTEM: electric with 12V battery.
GEARBOX: hydrostatic transmission.
DIFFERENTIAL: with lock device.
CLUTCH: electromagnetic with P.T.O and with blade brake.
GROUND SPEED: from 0 to 10 km/h with continuous variation and reverse from 0 to 6 km/h.
TYRES front: 13×5.00-6 rear: 17×8.00-8
BRAKE: front emergency brake and rear parking brake.
OPERATOR SEAT: adjustable comfort seat with armrests.
CUTTING DECK: rear/side discharge.
CUTTING SYSTEM: rotating with 1 blade.
CUTTING WIDTH: 910 mm (±36'')
CUTTING HEIGTH: from 30 to 90 mm (from ± 1.2'' to ± 3.5'') with 4 different cutting positions and 1 transfer position.
WORK CAPACITY: approx. 7200 m²/h (± 1.7 acres per hour)
STEERING RADIUS: 380 mm (±14.9'')
FUEL TANK: 13 litres - RESERVE: 3 litres - FUEL LEVEL INDICATOR
Climber 9.22/ Translation of the original instructions
IDENTIFICATION AND SERVICING
TECHNICAL SPECIFICATIONS
6
Climber 9.18 – 9.22 has a label under the dashboard
indicating the machine's serial no.
service centre if