Grillo CLIMBER 9.18 Notice D'emploi page 14

CAUSE

Battery not supplying power
Dashboard ON, but starter motor does not turn over with key in "AVV" (ON) pos.
– Battery not supplying enough power
– Start-up go-ahead not given
– Carburettor problems
– Deposits or dirt in fuel
– No petrol flow
– Fault in ignition system
distance apart.
– Speed too high for cutting height
– Cutting deck not parallel to ground
– Blades fault
Climber 9.22/ Translation of the original instructions
TROUBLE-SHOOTING
PROBLEM
Dashboard OFF with key in "AVV." (ON) pos.
Difficult starting or irregular running of engine
Starter motor turns over but engine does not start
Drop in engine performance during cutting
When the blades are engaged the engine cuts out
Uneven cutting
11
REMEDY
– Check connecting cables
– Check electrolyte level
– Recharge battery
– Change the fuse
– Recharge battery
– Travel lever in stop position
– Disengage blades
– Sit in the driver's seat
– Clean or change the air filter
– Adjust the carburettor (follow engine manual instructions)
– Empty the tank and use fresh petrol
– Check and change the petrol filter if necessary
– Check that the choke has been activated (if engine is cold)
– Check petrol level in tank
– Check wiring of carburettor opening control
– Check petrol filter (and change if necessary)
– Check that the vent on the tank cap is not blocked
– Check that the caps of the spark plugs are correctly
fastened
– Check that the electrodes are clean and at the correct
– Reduce speed
– Go-ahead not given for blade engaging
– Check the blade-engaging microswitch
– Sit in the driver's seat
– Check tyre pressure
– Level off the deck
– Check that the blades are correctly mounted
– Sharpen or change the blades
– Check the tension of the cutting deck engine belt