Keysight U1281A Guide De L'utilisateur page 31

This warning is intended to stop you from attempting to measure voltage, continuity,
resistance, capacitance, diode, or temperature values when the leads are plugged into a
current terminal.
The red LED on the multimeter turns on briefly and the multimeter emits a brief beep and
displays
current position but no test leads are inserted into the
Figure 1-5
Adjusting the tilt stand
To adjust the multimeter to a 60° standing position, pull the tilt-stand outward to its
maximum reach.
Figure 1-6
Keysight U1281A/U1282A User's Guide
in the secondary display when the rotary switch is set to the
Input warning display
Tilt-stand adjustment and IR-USB cable connection
Introduction
or mA input.
A
To PC (host)
1
or
mA
A
31