Keysight U1281A Guide De L'utilisateur page 24

1 Introduction
1 Remove the orange rubber holster.
2 Loosen the two screws with a suitable
4 Lift the inner rubber cover to access the
5 Observe the proper battery polarity. The
The battery level indicator at the lower left-hand corner of the display indicates the relative
condition of the batteries. To ensure that the multimeter's battery level indicator is
24
Push from a top corner and stretch the
orange rubber holster off the
multimeter.
Phillips screwdriver as shown on the
right.
battery compartment.
terminal ends of each battery are
indicated inside the battery
compartment. Insert four 1.5 V AA
batteries.
3 Lift and remove the battery cover as
shown on the left.
6 Ensure that the inner rubber cover is
positioned properly.
7 Replace the battery cover back in its
original position and tighten the screws.
8 Finally fit the orange rubber holster
back on the multimeter.
Keysight U1281A/U1282A User's Guide