Publicité
Les langues disponibles
Les langues disponibles
Setup Menu Items
Changing the variation count
This setting is used with the multimeter's AutoHold feature (see page 106). The default
setting is 50 counts (0050) based on the low definition display (dddd). The default setting is
multiplied by 10 when you switch to the high definition display (ddddd). When the variation
of the measured value exceeds the value of the variation count, the AutoHold feature will
be ready to trigger.
Parameter
AHoLd
To change the variation count:
1 Press
2 Press
Figure 4-1
3 Press
4 Press
step 3 to edit.
5 Press
6 Press and hold
Keysight U1281A/U1282A User's Guide
Range
(0001.d to 9999.d) or (0001.E to 9999.E)
while turning the rotary switch to access the Setup menu.
Shift
Esc
or
on
until
Hold
AHoLd display
Vsense
or
to set the variation count.
or
on
to navigate to the consecutive values, then repeat
Hold
to save your changes, or press
Hz
Save
until the multimeter restarts to return to normal operation.
Shift
Esc
Multimeter Setup Options
Default setting
0050.d (disabled)
is shown on the secondary display.
to discard your changes.
Shift
Esc
4
121
Publicité
