Publicité
Les langues disponibles
Les langues disponibles
Recording Measurement Data (Data Logging)
The Data Logging function provides you the convenience of recording test data for future
review or analysis. Since data is stored in the nonvolatile memory, the data remains saved
even when the multimeter is turned OFF or if the battery is replaced.
The Data Logging feature collects measurement information over a user-specified duration.
There are four data logging options that can be used to capture measurement data: manual
(
A manual log stores an instance of the measured signal each time
more than 1 second. See page 108.
An interval log stores a record of the measured signal at a user-specified interval. See
page 108.
An event log stores a record of the measured signal each time a trigger condition is
satisfied. See page 110.
A export log stores a record of the measured signal and exports it via the multimeter's
optical communication port each time
Table 3-1
Data logging option
Export
Manual (
Interval (
Event (
Before starting a recording session, set up the multimeter for the measurements to be
recorded.
Select the data logging option
1 Press
2 Press
3 Press
Available options:
4 Press
Keysight U1281A/U1282A User's Guide
), interval (
), event (
Data logging maximum capacity
(
)
)
)
)
while turning the rotary switch to access the Setup menu.
Shift
Esc
or
on
Hold
icon appears to the left of the secondary display.
Vsense
or
to change the data logging option.
,
to save the changes. Press and hold
Hz
Save
), or export (
).
is pressed. See page 111.
Hold
Maximum capacity for saving
100
100
10000
Shares the same memory with Interval logging
until
is shown on the secondary display and the
, or
.
Shift
Esc
Multimeter Features
is pressed for
Hz
Save
until the multimeter restarts.
3
107
Publicité
