Keysight U1281A Guide De L'utilisateur page 131

Changing the continuity type
This setting is used to indicate the circuit type at which the alert sounds for resistance and
diode measurements. You may choose the alert type under page 132.
Parameter
tYPE
To change the continuity type:
1 Press
2 Press
Figure 4-12
3 Press
4 Press
5 Press and hold
Keysight U1281A/U1282A User's Guide
Range
oPEn, SHort, or tonE
while turning the rotary switch to access the Setup menu.
Shift
Esc
or on
Hold
icon appears below the secondary display.
tYPE display - continuity
Vsense
or to set the continuity type.
to save your changes, or press
Hz
Save
until the multimeter restarts to return to normal operation.
Shift
Esc
until is shown on the secondary display and the
to discard your changes.
Shift
Esc
Multimeter Setup Options
Default setting
SHort
4
131