Parkside PKGA 20-Li C2 Traduction Des Instructions D'origine page 54

GB MT
Troubleshooting
The following table will assist you in fixing faults:
CAUTION! Risk of injury! In the event of an accident or malfunction, remove the battery
device immediately.
Problem
Device does not start
Device works with interrup-
tions
Attachment tool does not
move although motor is run-
ning
Low appliance power
Attachment tool wears
down quickly
54
Possible cause
Rechargeable battery (10)
not inserted
On/Off switch (15) is
broken
Worn out carbon brushes
Rechargeable battery (10)
discharged
Internal loose contact
On/Off switch (15) is
broken
Device attachment or at-
tachment tool not correctly
mounted
Attachment tool unsuitable
for the workpiece to be pro-
cessed
Attachment tool blunt or
worn down
Incorrect speed
Low battery power
Attachment tool unsuitable
for the workpiece to be pro-
cessed
Too much pressure applied Reduce the pressure
Speed too high
Troubleshooting
Insert the rechargeable bat-
tery (see Inserting the bat-
tery , p. 49)
contact the service centre.
Charge the battery (Char-
ging the battery, p. 47)
contact the service centre.
Correctly mount the device
attachment or attachment
tool (see Preparation,
p. 44)
Insert a suitable attachment
tool
Insert a new attachment
tool
Adjust speed
Charge the battery (Char-
ging the battery, p. 47)
Insert a suitable attachment
tool
Reduced speed