Parkside PKGA 20-Li C2 Traduction Des Instructions D'origine page 44

GB MT
facturer of the implant before operating
the machine.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
Control elements
Familiarise yourself with the operating
elements before using the device for the
first time.
• Direction of rotation switch (8)
NOTICE! Only operate the direction
of rotation switch when the tool has
stopped!
The arrow on the direction switch (8)
indicates the working direction.
• Screw in screw, drill
• Centre Switch lock
• Unscrew screw
• On/Off switch (15)
• Switching on: Press
• Control the speed progressively:
The further you press the on/off
switch, the higher the speed.
• Switching off: Release
Replacing the appliance
attachment
Notes
• Set the direction of rotation switch
(8) to the centre. These safety meas-
ures prevent accidentally starting the
power tool.
CAUTION! Risk of burn injury!
•
The device attachments may be very
44
hot after use. Wear protective gloves
whenever appropriate.
Remove the device attachment
(Fig. A)
1. Push the unlocking lever (6) into po-
sition as far as the stop and then
hold it in this position.
2. Remove the unlocked device attach-
ment (5, 24, 30).
Mount the appliance attachment
(Fig. A)
1. Push the device attachment (5, 24,
30) along the guide rail into the mo-
tor unit (7).
2. Allow the unlocking lever (6) to slide
back into position
NOTICE! Check that the appliance
attachment is secure by pulling on it.
Supplied device attach-
ments and attachment
tools
Drill attachment PKGA1
Control elements
• Torque adjustment ring (3)
Setting of the maximum torque for
screwing at which the slipping clutch
is disengaged.
NOTICE! Only operate the torque
adjustment ring when the device is at
a standstill!
• 1 lowest torque
• 19 highest torque
To be safe, start with a low torque
when screwing. Increase torque
ac-cording to requirement.
.