Hatco THERMMAX Salamander TMS2-1H Serie Manuel D'instructions page 9

4. Press the desired Cook Function button (
• The Cook Function buttons are pre-programmed at the
factory as follows.
= 05:00,
• The timer will start and the heating elements will turn on.
5. When time expires, an audible "beep" signal will indicate
that the Cook cycle is complete. The heating elements will
turn off.
6. When cook cycle is complete, do one of the following:
• Press the Hold button (
on at 25% of their maximum power/intensity.
• Press the desired Cook Function button (
continue cooking at full power/intensity.
• Replace the food product to restart the timer and turn on
the heating elements.
NOTE: The operator can choose a different Cook function
setting at any time during operation of the unit.
NOTE: The operator can pause the cook cycle at any time
during operation of the unit by removing the food from
the cooking grate or pressing the
Manual Cook Function
1. Move the upper housing to the desired cooking height.
2. Place food product onto the cooking grate.
3. Press the Auto/Manual button (
Manual mode setting.
• The indicator light will turn off when the unit is in Manual
mode.
4. Press the desired Cook Function button (
• The Cook Function buttons are pre-programmed at the
factory as follows.
= 05:00,
5. Press the Start/Stop button (
on the heating elements.
6. When time expires, an audible "beep" signal will indicate
that the cook cycle is complete. The heating elements will
turn off.
7. When cook cycle is complete, do one of the following:
• Press the Hold button (
elements on at 25% of their maximum power/intensity.
• Press the desired Cook Function button (
continue cooking at full power/intensity.
• Replace the food product and repeat this procedure.
NOTE: The operator can choose a different Cook function
setting at any time during operation of the unit.
NOTE: The operator can pause the cook cycle at any time
during operation of the unit by pressing the
Form No. TMS2CEM-1021
= 10:00, = 15:00
) to keep the heating elements
button.
) until the unit is in the
= 10:00, = 15:00
) to start the timer and turn
) to keep the heating
button.
).
Place food product
onto cooking grate.
) to
Holding Mode
When in Holding mode the overhead heating elements operate
at 25% of their maximum power/intensity to maintain the
cooking temperature reached during the cooking cycle.
NOTE: The Hold button (
after a cooking cycle.
NOTE: The Hold button's power/intensity setting can be
adjusted. Refer to the "Adjusting the Hold Button
Power/Intensity Settings" procedure in this section.
1. Move the upper housing to the desired holding height.
2. Press the
).
• The indicator light above the
3. When holding is complete, turn the Power I/O (on/off) knob
to the O (off) position. The heating elements will turn off
and all indicator lights will turn off.
Adjusting Cook Function Timer Settings
The Cook Function stimer settings can be adjusted using the
following procedure.
1. Press and hold the desired Cook Function button
)
(
2. Press the
timer setting shown on the LED Display to the desired
setting.
) to
3. Press the same Cook Function button to lock in the change.
Adjusting Hold Button Power/Intensity Settings
The Hold button's power/intensity settings can be adjusted
using the following procedure.
1. Press and hold the Hold button (
2. Press the
power/intensity setting shown on the LED Display to the
desired setting.
3. Press the
9
OPERATION
Lower upper housing to
increase heat intensity,
raise to decrease.
Operating the Salamander
) can be pressed before, during, or
button.
button will illuminate.
for 3 seconds.
and buttons to increase or decrease the
) for 3 seconds.
and buttons to increase or decrease the
button to lock in the change.