Measuring Reference; Mount Your Device On Tripod - TOOLCRAFT LDM 50 U Notice D'emploi

Measuring Reference

1. By default, reference is set at rear.
2. The device has three references: rear, middle (tripod thread) and
front.
3. To change the reference, press
4. Changing sequence is front -- > middle -- > rear.

14. Mount your device on tripod

1. To set the device on a stable base, the device could be fixed on
a tripod.
2. Thread is at the back of the device. size is 1/4".
Tripod Thread
, each press will take effect.
Indicator for reference
49