Dyna-Measuring (Continuous Measuring) - TOOLCRAFT LDM 50 U Notice D'emploi

11. Dyna-Measuring (Continuous
measuring)
1. By default, every single measurement is under normal mode.
2. Press and hold
Measuring Mode (continous measure).
3. When entering Dyna Measuring Mode, laser beam will be also
activated.
4. Now, aim at your target then press
measuring.
5. While measuring, the minimum value will be shown at the sub-
screen.
6. To stop the Dyna Measuring, press
7. To show the maximum value on the sub-screen, press and hold
42
Normal Measuring Mode
to switch from Normal mode into Dyna
Switch to Dyna-Mode
Operating in Dyna-Mode
, to enable dynamic
.