Measuring Modes; Single Measurement - TOOLCRAFT LDM100H Mode D'emploi

• The measurement from the laser exit edge is signalled
as measurement from the lower edge of the device by a
lower beep. The respective tone also confirms switching
between the edges.
The device length is considered in the displayed
measured result. When measuring from the lower
edge, the device length is added up automatical-
ly. Changes to the device length falsify the meas-
uring result.
e) Measuring modes

Single measurement

See chapter 8 b.) Triggering a Measurement
Continuous single measurement
• Push and hold the
sound signal is given.
• The distance between the device and the projected laser
point is measured continually. The current distance is dis-
played in the bottom-most line.
• To transfer it into the measured value storage, push and
hold the
• Continuous measurement is continued and can be left
with the
(1) - MEAS button, until the first
(1)- MEAS button.
(10) - CLR button.
51