Stake-Out - TOOLCRAFT LDM 50 U Notice D'emploi

when the Dyna Measuring is stopped.
8. To restart Dyna Measuring, press
9. To quit Dyna Measuring mode and go back to normal mode, press
.

12. Stake-out

The product provides two sets of stakes for the stake-out jobs.
Set the stakes
At least one set of stakes has to be saved in order to use the stake-out
function.
1. Press for three times to set the first stake.
2. Press to increase the value, press
3. Hold to shift the digit to the left, hold
the right.
4. Press to set the second stake. If you don't need the second
stake, set it to zero. You may press
set the value to zero.
Measuring with stakes
.
the decrease the value.
to shift the digit to
and at the same time to
43